Water-based all-round lacquer suitable as jewellery lacquer for gold and silver plating, clear, 5 ml

Water-based all-round lacquer suitable as jewellery lacquer for gold and silver plating, clear, 5 ml

EUR 7,60


5 ml. bottle with brush. Milky white lacquer that dries to an invisible finish, water-based surface lacquer that enhances all surface coatings and protects against any allergens from the metal. The lacquer is brushed onto exposed areas of gold-plated or silver-plated jewellery parts. Lasts approximately 3-6 months with normal use, after which it is recommended to repeat the application. You can apply several coats afterwards for extra strength. The varnish also prevents oxidation and other discolouration of silver and other metals.
 

Teknos Clear Aqua Lacquer
is a high-quality, water-based product for protecting a wide range of surfaces. Apply the varnish with a brush on a cleaned surface, place the item on a hard surface, not paper, as it will stick. The varnish dries in 1-2 hours in a well-ventilated location.

Contents 5ml. causes eye irritation on contact (rinse with water), keep out of reach of children, non-flammable.


Model/Product no.: 31141-6ml

Customers who bought this product also bought

Kit for making 2 necklaces and bracelets, including clasps, thread, wire clips, etc.

3133fgA-0.38mm


A kit for making necklaces with beads ranging in size from 8 mm to 14 mm. The kit contains 2 metres of 0.38 mm beading wire (tiger tail), 10 pcs wire crimp beads, 2 pcs 11 mm lobster clasps and 10 pcs closed jump rings size 5x0,8mm in the appropriate size.
To close the wire clamps, you will need a chain nose pliers or wire-crimping pliers (not included).
The length of a standard necklace is approx. 44 cm. Therefore, if you divide 44 cm by the diameter of your chosen beads in cm, you will see the required number of beads. All types of beads can be used.

EUR 12,63

Show product

Kit for making 2 lightweight necklaces or bracelets, including clasps, thread, wire clips, etc.

3133fgA-0.3mm


A kit for making necklaces with beads ranging in size from 2 mm to 6 mm. The kit contains 2 metres of 0.3 mm beading wire (tiger tail), 10 pcs wire crimp beads, 2 pcs 9 mm lobster clasps and 10 pcs closed jump rings size 4x0,7mm.
To close the wire clamps, you will need a chain nose pliers or wire-crimping pliers (not included).
The length of a standard necklace is approx. 44 cm. Therefore, if you divide 44 cm by the diameter of your chosen beads in cm, you will see the required number of beads. The length of a standard bracelet is typically 18 mm. All types of beads can be used.

EUR 12,11

Show product