Hammer for silversmithing, double-sided, steel, 11 heads, black, 230x70x14 mm, 1 pc

Ring measuring kit, find your ring size, with European units, handy tool for measuring diameter and size of finger rings, iron on steel wire, inner diameter from 13.5-25mm, corresponding to measurements 42 to 76 (circumference in mm).

The Ring Ratchet is a jeweller's tool for shaping silver parts and the like, this square variant is made of hardened steel, length 34.5 cm, width tip 6.5 mm shaft 18 mm. Please note this is not a measuring tool

Set of 5 jewellery hammers for jewellery making and silver work. With varying striking surfaces. The hammers are made of stainless steel with a wooden handle, length 22 cm, depth 6.5 cm, width without striking surfaces 13 mm. Suitable for processing jewellery parts such as silver plate, wire, etc. Practical wooden tool holder included.

Hammer for jewellery making and silver work. With 9 different interchangeable stainless steel striking surfaces / trajectories as shown. The hammer is made of stainless steel with a wooden handle, length 25 cm, depth 7 cm, width without striking surfaces 25 mm. Suitable for processing jewellery parts such as silver plate, wire, etc. The striking surfaces can be unscrewed and replaced as needed.

Hammer for jewelry making and crafting. With two interchangeable striking surfaces in plastic and rubber for a gentle and even blow. The hammer is made of stainless steel with rubber grip, Length 26.5 cm, Width 6.5 cm, Depth 2.5 cm, not suitable for regular nails. Use it for parts that must not be scratched, bent or otherwise damaged such as silver plates, glass plates, tent pegs, wooden parts, etc.

Practical set for sawing/cutting silver and other metal jewelry parts. The saw comes with 24 blades and a board and cramp, so you can easily save in silver plate and wire. Make your own jumprings cheap. Wind silver thread (or similar) close on a knitting needle for a long spiral. Next cut the coil through on the one hand, starting from the top downwards. Pull the knitting needle out slowly as the rings loose.

Ring measuring mandrel is a handy tool which allows you to accurately size diameter and sizes on finger rings, length 260mm, made of plastic. Note, rings are not included.

Ring mandrel is a handy tool which allows you to accurately size diameter and sizes on finger rings, length 255mm

The ring bolt is an indispensable goldsmith tool for forming finger rings, hoops and the like, it is made of hardened stainless steel, length 260 mm, diameter range from 11 mm to 24 mm. Note this is not a measuring tool, if you want to measure the size of finger rings you must use a ring size stick instead.